Working table exchange mechanism of automatic fiber laser cutting machine
Automatic fiber laser cutting machine part-time station interchange mechanism, including frame assembly, part-time station, second part-time station, and drive system. The frame assembly is equipped with track components corresponding to the part-time station and the second part-time station. The second track assembly corresponding to the platform, the track assembly includes two parallel tracks; the second track assembly includes a sigmoid track, a front wheel down track and a rear wheel up track, and a transition track is provided between the rear wheel up track and the scribble track; The lower level track I of the rear wheel up track, the lower level track II of the front wheel down track, the bottom section of the polygonal track, and the track are in a uniform level. This book has a simple layout, low cost, and high reliability. The part-time table and the second part-time table act in parallel. The initial position and the cutting position are at the same level. The Z-axis distance is reduced, and the cutting accuracy and cutting results are greatly improved. .
Automatic fiber laser cutting machine part-time table interchange mechanism, including frame assembly, part-time table, second part-time table, drive system, the frame assembly is equipped with The track assembly corresponding to the part-time station and the second track assembly corresponding to the second part-time station. The track assembly includes two parallel tracks; the second track assembly includes a polygonal track, a front wheel down track and a rear wheel up track, and the rear wheel goes up. There is a transition track between the track and the zigzag track; the lower track I of the rear wheel up track, the lower track II of the front wheel down track, the bottom section of the zigzag track, and the track are in a unified level. This book has a simple layout, low cost, and high reliability. The part-time table and the second part-time table act in synchronization with each other. The initial position and the cutting position are at the same level. The Z-axis distance is reduced, and the cutting accuracy and cutting results are greatly improved. .