System structure of automatic optical fiber cutting machine

Compared with other capacitive height controllers on the market, the Taiwan-group automatic fiber cutting machine has the following specific differences: based on the design of the DCS architecture concept, the latest high-integration digital circuit composition from abroad. Its advanced nature and novelty can be called. All-round compatible design, the Z-axis follow-up system of the MTZ-2 group automatic fiber cutting machine can be embedded and run with any manufacturer's control software, or it can be loaded with the machine's special software for compatible operation, even without any host software Z-axis follow-up Automatic operation. The unique cone design will not be scratched when there is a film on the cutting metal surface. At the same time, the nozzle and the cutting metal surface are the smallest relative area, which greatly improves the stability and reliability of the entire system. It is currently other adjustments. Incomparable to the device. Cross-hole design, in the process of cutting the part of the media plate with holes, the height controller will automatically adjust the position when the cross-hole is encountered to prevent it from colliding with the board, and it will not affect the subsequent cutting. Anti-interference design, in addition to the system has the smallest relative surface and has suppressed interference to a minimum, the system can also perform custom filtering, design filter parameters, and remotely configure the computer to complete the filtering without restarting, which greatly improves the stability Sex. Computer remote configuration, the height controller can be connected to the computer through a common twisted pair cable to realize remote configuration, modify the automatic height of the height controller, the current height controller cuts the medium, modify the reset height and the cutting mode.

The computer remote monitoring of the group of automatic fiber cutting machines, the computer can monitor the working status of the height controller at the same time, and the current height of the height controller is detected and displayed on the computer, and It is stored in the database for easy maintenance. At the same time, the current height of the height controller can be adjusted remotely in non-automatic mode, which is convenient for remote cutting. Technical indicators Power supply voltage: AC220V±10%, 50Hz/60Hz lifting motor: high-performance stepping motor Operating temperature: controller -10∽60℃, sampling coaxial cable: -10∽150℃, probe assembly: -10∽250 ℃, follow-up accuracy: ±0.2mm nozzle relative height reference setting adjustment range: 1.0mm~4.0mm greater output power: according to the matching motor driver controller housing size: 130*75*40mm detection sampling area: 5mm sampling the same Shaft cable length: 500mm±200mm (customized) Capacitance detection accuracy: ±0.01pF greater operating speed: related to stepper motor and screw rod detection sampling frequency: 40 times/sec. System structure MTZ-2 type automatic optical fiber The Z-axis follow-up system of the cutting machine consists of four parts: the Z-axis follow-up controller, the nozzle sampling probe, the power junction box and the matching cable, and the Z-axis follow-up system of the MTZ-2 group automatic fiber cutting machine. software. The schematic diagram of the system structure is as follows: Installation and interface blowing signal: connect the blowing signal pin to the normally open contact of the blowing relay of the group automatic fiber cutting machine, when the group automatic fiber cutting machine machine starts blowing When the time, the follow-up system starts to automatically adjust the height, when the blowing is closed, the Z-float system will stop working. Laser signal: connect the laser signal pin to the normally open contact of the light relay of the automatic fiber cutting machine. When the automatic optical fiber cutting machine emits the laser, the system automatically adjusts its height. When the automatic optical fiber cutting machine emits the laser, the system automatically adjusts the height. When the machine turns off the laser and blows air to cool it, the laser head will be pulled up to facilitate the replacement of materials.