Regular inspection and maintenance of automatic fiber cutting machine manufacturers

Taiwan group of automatic fiber cutting machine manufacturers tools: color marking tools for different purposes; dust-proof article placement methods, etc.; safety standards: prohibited signs; protective signs; warning signs; fire hydrant signs; fire evacuation Signs, etc., such as passages, oil storage, water, electricity, gas, and other reminder signs. Safety construction in the process of training and teaching While training safety pays attention to system construction, it is more important to integrate these systems and regulations into the daily training and teaching process and course implementation. Combining practical teaching content with practical training safety, the training instructor should focus on several aspects: one is to grasp the three stages of safety education and summary before class, during class and after class; second, to strictly abide by the operation of equipment and equipment Regulations and dressing meet the requirements; the third is to combine the safety operation procedures of equipment and equipment with practical training operation procedures, and product production training; the third is a safety pre-plan mechanism. Other supporting conditions for the safe construction of the main instrument and equipment training room of the supporting training base, as well as other auxiliary devices, such as the air compressor room, the grinding wheel room, the material room and the oil storage area. These auxiliary devices have hidden dangers or dangers such as pressure, noise, dust, peculiar smell, electricity and fire. In addition to having a special storage location, it must be inspected and maintained regularly as the equipment for training and teaching. If it does not meet the national safety standards, it must be rectified immediately. The mechanical training safety of vocational colleges is the same as the production safety of industrial enterprises. Both involve personal and equipment safety. To achieve no accidents or fewer accidents, on the basis of referring to the enterprise and 5S management, formulating a safety responsibility system that meets the actual conditions of the company and fulfilling these are important means to ensure safety in training. The flame fiber laser cutting machine is mostly used for cutting medium and large thickness carbon steel. The reason is that the cutting cost is low, but it has the disadvantages of large cutting deformation, low precision, and low cutting speed. Therefore, the application is mainly limited to the cutting of medium and large thickness plates of carbon steel.

In order to improve the accuracy of this cutting machine, we usually use CAD software to find the cutting machine through the approximate discrete method or the drawing method. , But these methods make or calculate approximate curves, which will produce large errors in the actual processing process, resulting in deviations when the pipes are butt or mitered, and the two workpieces cannot be closely attached, and the gap during welding is too large. , Making the artifact scrapped. Let’s introduce how to draw and output the cutting machine through Solidworks software. For single-boom portal cranes, the boom mostly uses seamless steel pipes as the structural material. Then the steel pipe and the steel pipe due to the angle, position, and pipe The difference in diameter leads to irregular connection at the pipe connection part. So we want to make the pipes fit tightly, or to achieve a gap between the pipes that can be welded. We will cut the left edge of the pipe for the part that needs to be welded with the main pipe after the pipe is cut at node A, which is the cutting machine. We use this cutting machine as the walking route of our cutting torch. Save the expanded view as a drawing mode. Delete the unnecessary lines on the remaining three sides. At this time, the obtained curve is a spline curve. Since the CNC fiber laser cutting machine of our factory can only read the curve in the form of a polyline, we need to explode this curve to get a polyline curve. Select this curve and click the automatic sorting as shown in Figure 5, or manually sort to get the path, and output the file to generate a 1.hex file for input to the CNC fiber laser cutting machine system.

This article is published by the original