Precautions for fiber laser cutting machine

The more concentrated beam of the fiber laser cutting machine produces a smaller focal point and a deeper depth of focus, so that the optical laser can cut thinner materials quickly and cut medium-thick materials more effectively. When cutting materials up to 6mm thick, the cutting speed of the 1.5kW fiber laser cutting system is equivalent to that of the 3kW CO2 Dunguang cutting system. Because the operating cost of fiber cutting is lower than the cost of an ordinary carbon dioxide cutting system, this can be understood as an increase in output and a reduction in commercial costs. There are also maintenance issues. The carbon dioxide laser system needs regular maintenance; the reflector needs maintenance and calibration, and the resonant cavity needs regular maintenance. On the other hand, fiber laser cutting solutions require almost no maintenance. The carbon dioxide laser cutting system requires carbon dioxide as a laser for maintenance: the reflector needs to be maintained and calibrated, and the resonant cavity needs to be maintained regularly. On the other hand, fiber laser cutting solutions require almost no maintenance.

The carbon dioxide laser cutting system of fiber laser cutting machine requires carbon dioxide as the laser gas. Due to the purity of carbon dioxide gas, the resonant cavity will be contaminated and needs to be cleaned regularly. For a multi-kilowatt carbon dioxide system, this project costs at least US$20,000 per year. In addition, many carbon dioxide cutting requires high-speed axial turbines to send laser gas, and the turbines require maintenance and overhaul. Finally, compared with carbon dioxide cutting systems, fiber cutting solutions are more compact and have less impact on the earth, so less cooling is required and energy consumption is significantly reduced. ???The combination of less maintenance and higher energy efficiency makes fiber laser cutting and carbon dioxide laser cutting systems emit less carbon dioxide and is more environmentally friendly. The simple operation process of the laser cutting machine is to start: (open the gas cylinder valve first) open the air switch, emergency stop, key switch (see whether the temperature of the water tank has an alarm display) 1. Turn on the computer, wait for the computer to fully start and then turn it on (Note: computer It cannot be turned on at the same time as the start) 2: Press the start button to see the display screen shows P, press the option to ON, and confirm (wait 90 seconds) 3: Turn on the motor, enable, follow, laser, red light, each button in turn. Shut down: Turn off the computer first, then turn off the motor, enable, laser, red light, the button, press the button, the display shows OFF, confirm, wait for P to appear, press the stop button again, turn off the key switch (control the water tank), press the emergency stop, turn off the air Switch off the air valve.

/