Necessary conditions for the normal operation of the automatic fiber cutting machine

Maintenance of laser tube of Taiwan-group automatic fiber cutting machine: The laser tube in Taiwan-group automatic fiber cutting machine is cooled by circulating water. After long-term use, there will be some white scale in the tube, and we can circulate it. Add a small amount of vinegar to the water, remove the water in the tube, and then use clean water to flush the inside of the laser tube, so that the laser tube will be in a better working condition and the life will be extended. During use, for safety protection and efficient production, the most important thing is the daily safety maintenance and maintenance of the equipment. Not only can the service life of the optical fiber laser cutting machine be extended, but also the processing quality of the production port can be maintained and improved at all times, and finally stable and high-efficiency can be realized. Warm reminder: For the following items, please be sure to achieve a good grounding laser power source. The Taiwan Group automatic fiber cutting machine itself must have good grounding protection, and the grounding wire should be smaller than the dedicated grounding wire. The necessity lies in: it can ensure the normal operation of the laser power supply, can prolong the service life of the laser tube, can prevent external interference from causing the group of automatic fiber cutting machines to jump, and prevent accidental circuit damage caused by high-voltage discharge. Good grounding, be sure! Cooling water should be smooth. Cooling water-cooled metal cutting and cutting machine. Whether it is tap water or circulating water pump, the water must be kept smooth. The cooling water takes away the heat generated by the laser tube, the higher the water temperature. The lower the optical output power, the tube end will burst due to the heat in the laser cavity when the water is cut off, and even damage the laser power supply. Therefore, it is necessary to check whether the cooling water is unblocked at any time.

Taiwan group automatic optical fiber cutting machine when the water pipe has a hard bend or fall off, and the water pump fails, it must be repaired in time to avoid power drop or even equipment damage. Cleaning and maintenance, good ventilation, and cleaning and maintenance of the Taiwan-group automatic fiber cutting machine at any time are necessary conditions for the normal operation of the Taiwan-group automatic fiber cutting machine. Imagine that people’s joints are not flexible, how can they move? In the same way, the machine guide rail is a precision core part. After each work is completed, it must be wiped clean to keep it smooth and lubricated. Each bearing must also be oiled regularly, so as to make the drive flexible, process, and prolong the service life of the machine tool. Ambient temperature and humidity The ambient temperature is in the range of 5-3535°C. In particular, note that if it is used in an environment below the freezing point, it must be done: to prevent the circulating water in the laser tube from freezing, and the water must be completely discharged after shutdown; when the laser is turned on, the laser current must be preheated for more than 5 minutes to work. In rainy days and humid environments, the laser power supply requires a longer warm-up time, and high voltage can be applied only after the moisture is exhausted to prevent high-voltage circuit breakdown. When the 'laser high voltage' key is used correctly and the 'laser high voltage' key is dialed in, the laser power supply is in the standby state. When it encounters 'manual light output' or computer misoperation, it will emit laser light, inadvertently hurting people and objects. Because of these requirements, each time a piece of work is completed, such as discontinuous processing, the 'laser high voltage' should be turned off at any time, the laser current can be turned off, and the operator is prohibited from leaving without authorization when the group of automatic fiber cutting machines are working, so as to avoid accidents. , It is recommended that the continuous working time is less than 5 hours, and you can rest for 30 minutes.