Laser automatic fiber laser cutting machine and laser tube base

Laser tube base body and automatic fiber laser cutting machine, the left side of the cutting machine body is equipped with a driving motor, the lower end of the driving motor remains unchanged and the motor base is maintained, and the lower end of the cutting machine body is divided into two sides with outriggers, outriggers The upper end does not change and continues the bottom of the cutting machine body; the right side of the drive motor rolls and continues the automatic shaft, the middle of the automatic shaft is fitted with the upper end of the support rod, the lower end of the support rod is welded with the cutting machine body, and the right end of the automatic shaft does not change and continues the tapered seat. The right side of the conical seat is a cone, which facilitates abutting against pipes of different diameters. After moving the multi-stage hydraulic cylinder along the guide groove, the laser beam generator follows the orbiting movement to complete the cutting of different positions and master the multi-stage hydraulic cylinder at the same time. The flexible length mobilizes the laser beam generator to move the height of the laser beam generator to complete the cutting of different heights. The rolling wheel mobilizes the rib bar to follow the rolling and then mobilize the rubber pallet and the core roller to move the pipe to be cut to clamp.

The sheet metal fixture of the automatic fiber laser cutting machine includes a placement disk, on which four corners are arranged with supporting posts, and the appearance of the placement disk is in a fit configuration There is an air duct box, the top of the supporting column is equipped with a clamp plate, and the supporting column above the clamp plate is sleeved with a rib sleeve, and the air duct box is equally spaced and symmetrically arranged with geometric groups for dust collection Double-sided adhesive strips are glued on the two side walls of the dust-absorbing board, and an end baffle is welded on the outer end of the dust-absorbing board, and a handle is arranged in the middle of the end baffle. The wall is equidistant and symmetrically welded with air duct pipes. During the assembly, when the smoke passes through the double-sided adhesive tape attached on both sides of the dust suction plate, the one-sided smoke particles and dust are absorbed by the viscosity of the double-sided adhesive tape, and the dust accumulation and smoke particles in the air duct box after permanent application are spared. The impact on the suction pump.