Improvement of fiber laser cutting machine technology
The fiber laser cutting machine regularly checks the water level in the water tank of the chiller. If the water level is too low, add pure water or deionized water in time. Check the electrical wiring terminals regularly and remove dust. Regularly check whether the joints in the water system are warm water, whether the pipeline is aging, and if there is water leakage, replace the relevant components in time. Regularly check the water quality in the water tank of the chiller. If the quality of the cooling water becomes poor, turbid, and its transparency decreases, all the degraded cooling water should be discharged in time and replaced with new cooling water. Clean the impurities on the filter element regularly. If the filter element is damaged, it should be replaced in time. The replaced filter element must use the standard poem core required by the manufacturer. Check and clean the optical system. Pay attention to the surface of the optical lens (reflector, focusing lens, etc.). Do not touch it directly with your hands, as this will easily cause scratches on the mirror surface. If there is oil or dust on the mirror surface, it will seriously affect the use of the lens, and the lens should be cleaned in time. It is strictly forbidden to clean the optical lens with water, detergent, etc. The surface of the lens has a special film. If you use these to clean the lens, it will damage the surface of the lens. Do not place the lens in a dark and humid place, as this will degrade the surface of the lens.
The surface of the lens of the fiber laser cutting machine must be clean. If there is dust, dirt, or moisture, it is easy to absorb the laser and cause damage to the lens film; at least it will affect the quality of the laser beam, and at worst, no laser beam will be generated. When the lens is damaged, it should be sent to the supplier for repair in time. Try not to use the damaged lens, otherwise it will accelerate the damage to the repairable lens. When installing or replacing the reflector or focusing lens, do not use too much pressure, otherwise it will cause the deformation of the lens, thereby affecting the quality of the beam. How to install or replace the optical lens. Before installing the optical lens, pay attention: wear clean clothes, clean your hands with soap or detergent, and wear light and clean white gloves; it is strictly forbidden to touch the lens with any part of your hand; Strive for the side of the lens and do not directly touch the coating surface of the lens. When assembling the lens, do not blow into the lens with your mouth: the lens should be placed steadily on a clean table with a few pieces of lens professional paper underneath. When taking the lens, be careful to prevent bruises and falls, and do not apply any force on the coating surface of the lens; the lens holder where the lens is installed should be clean, and clean the dust and dirt in the lens holder with a clean air spray gun. Then, gently put the lens into the lens holder. When the lens is installed on the lens holder, do not use too much force to fix the lens, so as not to deform the lens, thereby affecting the quality of the beam.