How to clean fiber laser cutting machine1
The fiber laser cutting machine is clean. The middle of the cutting area is equipped with a rectangular tube, the top of the rectangular tube is equipped with teeth, the cutting area in the rectangular tube is equipped with chip removal holes, the cutting area is equipped with a storage cavity, and the top row of the storage cavity The chip hole is connected to the outside. The top of the storage cavity is connected with the water inlet pipe. The water inlet pipe is equipped with a water inlet valve. The bottom of the storage cavity is connected with the discharge pipe. The discharge pipe is equipped with a discharge valve. The storage cavity is equipped with a suction fan. The suction fan is located in the discharge pipe. Below the chip hole. It can easily pump away the gasified solids to ensure the normal operation of the equipment. The electric fan can suck the gasified solids from the chip removal hole, and then touch the water in the storage cavity to solidify the negative gasification material. The squeezing pipe squeezes out the waste water and injects new water into the storage cavity through the water inlet pipe to ensure normal application .
A plane fiber laser cutting machine that is easy to clean; arrange block, top plate, bottom plate, two sets of side plates and gun body; also support table, clean box and discharge tube, clean The inside of the box is equipped with a clean cavity, the top of the clean box is connected with a feed port, and a blocking cover is screwed at the feed port, and the input end of the discharge pipe is connected with a discharge pump, and also a connecting pipe and a connecting hose. It also includes the adjustment spring group and the invariant ring. The invariant ring is equipped with notches, and also houses the pipe and the disassembly tube. The outer side of the disassembly tube is equipped with a sponge wiper. It also has an auxiliary vibration spring, an auxiliary vibration plate and a waterproof oscillator, and it is waterproof. The oscillator comes with a power supply module. There are also two sets of continuous rods, a hand-held board and a scraper. The left and right sides of the top of the arrangement block are equipped with slide rails in the front and rear directions, and the two sets of slide rails can slide without a slider. It also includes a retractable tube set and a spring set.
In the discharge mechanism of fiber laser cutting machine, the top of the bottom plate is fixed with a discharge bucket, and the inner bottom wall of the discharge bucket is unchanged with two rare quantities. Lifting the push rod, the output end of the raising push rod is fixed with an extension rod, and the tops of the two extension rods are constant with the carrier board. The discharging mechanism for the fiber laser cutting machine is equipped with an extension rod on the lifting push rod. When the user applies the equipment, the user arranges the waste in the discharge bucket, turns on the ash collecting air pump, and the ash collecting air pump extracts metal powder When entering the filter box, the atmosphere filter holes are squeezed, and the powder remains in the filter box. When the user picks up large pieces of metal waste, he opens the lifting push rod and the carrier plate rises. The user can easily take the waste without pulling it inside. The waste, which relieves the users of the annoyance, facilitates the users to obtain materials.
/