Fully automatic fiber laser cutting machine works outside the scope of the sheet
When the word 'HV START' appears on the laser operation panel of the automatic fiber laser cutting machine, the red indicator light of the laser lights up, and the alarm 'LASER H-VOLTAGE NOTREADY' previously displayed on the upper right corner of the CNC system disappears, indicating that the high voltage is normal and the laser is on standby. Status. 10. Confirm the type of material, material thickness, and material size before cutting. Note: Check whether all cutting heads are correct. When cutting non-metallic materials, you must use a contact cutting head (plus a non-metallic detection ring). 11. Adjust the plate to make Its edges are parallel to the X and Y axes of the machine tool to prevent the cutting head from working outside the range of the plate. 12. Move the Z axis to the starting point of the cutting and simulate the program to be executed to ensure that there will be no over-soft limit alarms, and enter the editing mode , Adjust the power, speed, and punching time according to the type and thickness of the material. 13. If you want to cut carbon steel plates, select oxygen in the manual mode, and adjust the barometer to cut the Kaibang Kitchen and Bathroom (Zhejiang) Co., Ltd. Operating Regulations KB-13- 2009 Page 3 Total 11 Pages Version 0th Revision Theme: The promulgation date of the laser cutting machine operating regulations; 2009-08-8 The cutting head works outside the range of the sheet.
Fully automatic fiber laser cutting machine 12 、Move the Z axis to the starting point, simulate the program to be executed, to ensure that the soft limit alarm will not appear, enter the editing mode, adjust the power, speed, and punching time according to the material type and thickness. 13. To cut carbon steel plate , Select oxygen in manual mode, and adjust the barometer to cut Kaibang Kitchen and Bath (Zhejiang) Co., Ltd. Operating Regulations KB-13-2009 Page 3 of 11 pages Edition 0th revision topic: Laser cutting machine operating regulations Issue date: 2009-08-8 The required pressure value. Then check the focus position, perform the coaxial inspection program to ensure that the laser beam passes through the center of the nozzle, and the Z axis follows to the surface of the plate, adjust and determine the spray distance from the plate surface (adjust the control box potentiometer) ). 14. After the above items are normal, it can be switched to the execution state and the workpiece can be cut. 15. If slagging, return of slag or other abnormal conditions occur during the cutting process, it should be suspended immediately to find out the cause and solve the problem Continue cutting to avoid damage to the equipment. 16. After the work is completed, shut down in the following order: 1) Turn off the high voltage of the laser. 2) Turn off the low voltage on the laser panel. 3) Disconnect the main power supply of the laser. 4) Turn off the chiller. 5) Disconnect the machine tool. Control the power supply (key switch), turn off the main power switch of the machine tool (OFF) 7) Turn off the air compressor. 8) Turn off the nitrogen and oxygen valves.