Fully automatic fiber laser cutting machine with large format and high power irregularity
A large-format, high-power, non-standard, fully automatic fiber laser cutting machine, including a floor, on which 6 equipment floor mats are uniformly arranged on the base of the floor, and a wall of screws on the floor of the equipment floor mat is continuously slippery. The rail mounting plate and the second slide rail mounting plate. The slide rail mounting plate is equipped with a wall screw of the floor mat to install the slide rail, and the second slide rail mounting plate is equipped with the wall screw of the floor mat. There is a sliding block on one end of the rail mounting plate, the second sliding block is sliding continuously on one end of the second sliding rail mounting plate, and the screw on one end of the sliding block and the second sliding block away from the floor continues to move. board. This is suitable for the new type of experience gripping claw to clamp the optical fiber, the laser cutter cuts the twisting optical fiber, after cutting one end, move the holder forward, and then move the index cutting position to the laser cutter.
A new type of full-automatic fiber laser cutting machine for plate and tube in the interchange field, including a part-time table, the part-time table is provided with a bracket, and the inner wall of the upper part of the bracket is not A sliding rail is installed on the sliding rail, a mobile car is arranged on the sliding rail, a laser cutting head is arranged under the mobile car, a limit plate is arranged on the part-time table, and a limit hole is arranged on the limit plate. The geometric cylinder under the limit plate continues with the part-time station, and there is no need to set two rare-quantity struts between the brackets, the struts are sleeved with a torsion plate, and the two ends of the torsion plate experience The pin shaft is provided with a cutting backing plate, the cutting backing plate is provided with a clamping column under the cutting backing plate, and the clamping column is matched with the limiting hole, and the cutting backing plate is divided with a plate moving mechanism for negotiating a pipe moving mechanism. Favorable results: The two cutting pads can be kept unchanged, which greatly reduces the time to change the pads, and effectively guarantees the cutting compliance.
This article was published by the original