Fully automatic fiber laser cutting machine open type interchangeable table

A full-automatic fiber laser cutting machine with a hole-opening exchange table, comprising a base and a bracket that continues at the lower end of the base. The middle of the base is provided with a rectangular opening, and the upper end of the base is continuously provided with a constant clamping rod. The upper end of the base is provided with a groove. The layout is simple. After entering the combined layout of the constant clamping rod, the behavior clamping rod and the sliding rod, the screw can be rolled in the forward and reverse directions to complete the constant clamping. The change of the interval between the holding rod and the manner of the clamping rod achieves the result of holding the workpiece. After the screw, the different pressure plate can be changed to adapt to the different workpiece, which expands the suitable limitation, and the clamping is strong. Very reliable, not easy to loosen during the cutting process, improve the accuracy of manufacturing and processing, diligent and frugal raw materials, reduce manufacturing costs, and have great suitability.

A full-automatic fiber laser cutting machine synchronization exchange table, including a cutting chamber, one side of the cutting chamber continuously has a base, and one side of the cutting chamber is equipped with a control cabinet. The top of the base slides continuously with a sliding box. The new-style layout is simple. During the cutting process, the swarf waste generated will fall into the sliding box through the arrangement of the sieve plate, start the motor, mobilize the belt to roll, and the belt mobilization does not change the rod to move, and then complete the seat to move. During this process, the second roller moves with the guide rail to mobilize the clean wheel to roll to complete the secondary cleaning. At the same time, the intermittent use between the runner and the arc block, and the cooperation of the spring, complete the movement of the rack The rack is meshed with the sector gear, and the continuous rod and the brush are mobilized to swing to complete the second cleaning. After two cleanings, the deposition of waste products is greatly reduced and the part-time job is clean and hygienic.

This article was published by the original