Fully automatic fiber laser cutting machine for high quality cutting

Fully automatic fiber laser cutting machine with high-performance fiber transmission and flexible processing can achieve high-quality cutting of any shape, and is suitable for cutting high-reflection materials such as copper and aluminum. High-efficiency cutting speed, low operating cost, doubled Return your investment. Low gas consumption laser produces no gas; unique air cutting 8mm stainless steel technology, no N2 consumption. Low energy consumption, energy saving and environmental protection, and extremely low power consumption, which is 20%-30% of traditional CO2 laser cutting machine , Low-maintenance non-reflective silver sheet, no need to adjust the light path, basically maintenance-free. High-efficiency workbench The workbench can be loaded and unloaded. The two workbenches are driven by a chain device to realize automatic exchange, which greatly improves the production efficiency. There are many options for processing format; 3mx1.5m, 4mx2m (length x width). b) Weekly maintenance of the laser 1) Check whether there is oil or water in the gas mixing unit of the light counter, and clean it if there is: Check the gas drying filter of the laser, if the color becomes red or white after 1/4 of the process, It needs to be replaced, and its normal color is blue. 2) Check the oil level of the vacuum pump. If it is not enough, add it. 3) Check that the filter of the chiller is fragrant and impurity. 4) Check whether there are impurities in the cooling water circuit of the gargle. c) Maintain the laser every six months. 1) Replace. Vacuum pump oil (refer to the manual of full light device for specific operation). 2) Check whether there is erosion phenomenon in the cold discharge pipe of the laser head of the laser light device. If there is, it should be treated in time or replaced. 3) Check whether the high-voltage cable is damaged. 4 )Clean up all the lenses inside the Luguang resonator, including front window mirrors, tail mirrors, mirrors, etc. 5) After cleaning the internal lenses of the laser, readjust the laser light output mode until the correct mode is reached.

Annual maintenance of the micro-optical unit of the automatic fiber laser cutting machine) Please take care of the cooling water zinc road. 2) Replace the cooling water in the chiller, 3) Check whether there is any leakage in the water circuit inside the resonance. Inspection and replacement of the cooling water circuit a) Loosen the acid collar, unplug the water pipe, and put the chiller in a suitable position: b) Open the water discharge valve of the chiller (in the lower part of the chiller), and drain the water in the water tank: c) Check whether there are any dirt and floating microorganisms in the water tank, and clean the inside of the water tank: d) Close the water Valve, fill the water tank with pure water, pay attention to the water level gauge, add water to 85%-95% of the total capacity of the water tank: e) Put the chiller in place, connect the water pipe, and check for water: f) Open The left door of the micro-optical unit has a water pipe with a blue quick interface cap at the bottom. Pull out the quick interface to empty the steaming house water in the water tank. After placing the inch, close the quick interface cap: g) Unscrew the water tank lid and mail Cooling water can be injected into it: h) The requirements for steaming aluminum water: 1) The PH value of the water is greater than 7 and cannot be acidic: The optical fiber low-light cutting machine is a new type of optical fiber optical device newly developed in the national department to output high energy density The laser beam is concentrated on the surface of the workpiece, so that the area irradiated by the ultra-fine focus spot on the workpiece is instantaneously melted and vaporized, and the laser spot is moved by the CNC mechanical system to realize automatic cutting. Which fiber laser cutting machine is real The high-mouth marketing and promotion platform Lubaozuo (Guangzhou) will take a look at the reputation products that have been used by many people. Lubaozuo optical fiber product line is developed based on the complete fiber optic cutting machine as a series of products. Professional manufacturer.

This article is published by the original