Fully automatic fiber laser cutting machine enclosed
A closed automatic fiber laser cutting machine, comprising a body, the top of the body is connected with a top cover, and the side wall of the top cover is slidably connected with a sliding door. This is suitable for the short structure of the new type. The exhaust fan is started, and the exhaust fan generates wind power. The wind blows the exhaust gas produced in the top cover through the air guide and suction pipe. In the middle of this process, the filter disc can filter the fine particles in the exhaust gas. Avoid exhausting and polluting the air. At the same time, the wind drives the fan blades to rotate. The fan blade history belt and pulley drive the filter disc to rotate, bringing the impurities filtered on the filter disc into the water in the water tank, purifying the filter disc, and filtering forward.
A full-automatic fiber laser cutting machine protective ceiling, including a U-shaped frame and a pallet that has undergone screws and continues at both ends of the U-shaped frame; the U-shaped frame is vertical The inner side wall of the directional section continuously has a number of guides that are continuously assembled, and the guide rods continue to the inner side wall of the U-shaped frame vertical section, the other end of the baffle is against the card board, and the two adjacent guide rods slide continuously in behavior In the sliding grooves provided at both ends of the board, the vertical section of the U-shaped frame is provided with a horizontal through hole that facilitates the sliding of the behavior board, and the length of the behavior board is greater than the length of the constant board. Simply advance the one-sided behavior board 3 without unnecessary destruction of the entire ceiling, which is more convenient to operate; it can effectively prevent the laser diffuse reflection and ensure the safety of part-time employees.
An automatic fiber laser cutting machine with height adjustment device, the left side of the cutting head body is fixedly built with two T-shaped blocks in the vertical direction, In addition, two straight rack blocks are fixedly constructed on the right side of the cutting head body in the vertical direction, and the inner left side of the follower mounting frame is provided with two T-shaped grooves in the vertical direction. The T-shaped block on the left side of the head body is slidingly connected to the T-shaped groove on the inner left side of the follower mount, and is located on the outer front of the follower mount on the right side of the cutting head body. The history motor is installed The base is constructed with a drive motor, and the output end of the drive motor is constructed with a rotating shaft. The other end of the rotating shaft penetrates through the front side wall of the follower mounting frame and is built on the rear side of the follower mounting frame. The gears at both ends of the rotating shaft are respectively connected to the cutting head. The two straight rack blocks on the right side of the body are meshed and connected to advance the cutting compliance of the automatic fiber laser cutting machine and the processing quality of the workpiece by the automatic fiber laser cutting machine.
This article was published by the original