Fiber laser cutting machine opto-electromechanical vertical control cabinet

The vertical control cabinet of the opto-electromechanical fiber laser cutting machine belongs to the technical platform of the vertical control cabinet. A vertical control cabinet of the opto-electromechanical fiber laser cutting machine includes a base, and a universal wheel is arranged under the base. And the upper end surface of the base is provided with a behavior rod at the corners, the upper end of the behavior rod is provided with a bracket, and the upper surface of the bracket is unchanged with a cabinet, and the front surface of the cabinet is on both sides. A button is arranged on the front end of the button, and a cabinet door is arranged on the front end of the button. The front surface of the cabinet door is close to the center to open a survey window, and the front surface of the cabinet door has a handle at the center position. The center of both sides of the cabinet body is provided with heat dissipation holes. It can facilitate installation and destruction during the application process, prevent dust while dissipating heat, facilitate the adjustment of the height of the cabinet, and optimize the application process.

The rewinding mechanism of the sheet metal fiber laser cutting machine includes a rewinding rack, a supporting rod, a tensioning rod, a coiling rod and a coiling motor. The rewinding rack is located On the back side of the sheet metal fiber laser cutting machine, the supporting rod, the tension rod and the coiling rod are arranged on the receiving rack in sequence and parallel to each other, and the tensioning rod is lower than the supporting rod and the coiling rod. The motor is arranged on the rewinding rack, one end of the coiling rod is continuously on the reeling motor through the behavior continuous device, and the tension rod can move up and down on the receiving rack. The tension on the metal sheet during the cutting process is moderate, and the tension on the metal sheet is evenly maintained with the time, so as to avoid the deformation of the metal sheet due to excessive tension, and to avoid the tension being too small so that the metal sheet cannot be straightened Not helpful for cutting.