Circuit Design of Fiber Laser Cutting Machine
The circuit design of the fiber laser cutting machine is more complete. All the travel switches and protection switches of the 6th generation machine adopt non-contact photoelectric sensor switches, which are more durable and stable than other contact mechanical travel switches, and are greatly reduced. The phenomenon of saw blade burst caused by switch failure in the past. 4: The fixture pallet adopts Connaught-plated guide post type and the moving part adopts wear-resistant copper sleeve. The structure is stable and durable, which improves the use time limit of a single saw blade and avoids the former dovetail pallet that is easy to wear and cause the saw blade burst. 5: The fixture is clamped with a rotary cylinder, which is relatively convenient to operate compared to ordinary cylinders and cylinders. You can make corresponding adjustments only by turning the handwheel. 1.1: AC315 hydraulic swing arm type welded pipe online automatic cutting machine or cutting table matching pipe making unit: 30 machine, small 40 machine, standard 40 machine Production standard: 6 generation cutting range: pu003d50.8 or less and the same specification rectangular pipe cutting ability ：Stainless steel s3.0mm, carbon steelu003d5.0mm Cutting drive mode: independent hydraulic drive, frequency conversion carriage return equipment Features overview: This machine is currently the most used mainstream model on the market, and the cutting machine gearbox assembly has more than ten It was introduced to the mainland from Taiwan a year ago and is a very mature product. The length of the machine is 2.2 meters, and the field test rectangle 25x25/0.5mm is cut into whole.
The fiber laser cutting machine avoids the phenomenon of saw blade burst caused by improper adjustment or improper clamping of the tube. AC330 hydraulic vertical welded pipe on-line automatic cutting machine or cutting table matching pipe making unit: standard 40 machine, increased 40 machine Production standard: 6th generation Cutting range: 963.5 or less and the same specification rectangular pipe Cutting capacity: stainless steel u003d 3.0mm, carbon Steel 5.0mm cutting drive mode: independent hydraulic drive, frequency conversion carriage return Equipment characteristics overview: this machine is an improved version of AC315 vertical, it feeds vertically when cutting, the cutting angle of the main machine can be adjusted back and forth, which has changed the saw caused by the fixed cutting angle of the previous vertical machine Fragmented teeth, deformation of the nozzle, and improved use of a single saw blade. 5.0mm cutting drive mode: independent hydraulic drive, variable must return and sound setting. Features Overview: This machine is an improved version of AC315, which feeds vertically when cutting. The cutting angle of the main machine can be adjusted back and forth, which has changed the broken teeth and nozzle deformation of the saw blade caused by the fixed cutting angle of the previous vertical machine, and has improved the use time of a single saw blade. The length of the machine is 2.5 meters, which can fully meet the requirements of various 40 units. Cutting task. 1.3: AC355 hydraulic vertical welded pipe online automatic cutting machine or cutting table matching pipe making unit: standard 50 machine production standard: 6 generations Cutting range: sp50.8-989 and rectangular pipes of the same specification Cutting capacity: stainless steel u003d 3.0mm, carbon Steel u003d 7.0mm Cutting drive mode: independent hydraulic drive, frequency conversion carriage return Equipment characteristics overview: this machine cuts into a vertical slide, the slide adopts high-strength trapezoidal hard rail and dubbed with trim spacing adjustment device, because of its slide The wide contact surface has high resistance, so when cutting medium and large pipes, the knife feed is stable and not easy to move in the morning, thereby increasing the use time limit of a single saw blade.