Automatic fiber laser cutting machine workpiece conveying control system

Starting from the overall design scheme, hardware design and software design of the control system of the laser's automatic fiber laser cutting machine and its internal workpiece transmission, it has deeply studied the laser's automatic fiber laser cutting machine and its internal workpiece transmission. The overall design of the control system. Therefore, the overall design of the control system for the internal workpiece transmission of the standardized laser automatic fiber laser cutting machine can be carried out in accordance with the practical application requirements and related standards of the laser automatic fiber laser cutting machine.

In the laser's automatic fiber laser cutting machine, the control system of workpiece transmission is a core component, which directly affects the actual operation of the laser's automatic fiber laser cutting machine The accuracy and efficiency of the laser will also have a key impact on the overall operation and application effect of the laser’s automatic fiber laser cutting machine. It can be said whether the overall application effect of the laser’s automatic fiber laser cutting machine is good or bad. The control system of the workpiece conveying plays a certain decisive role. However, due to the laser's automatic fiber laser cutting machine, the overall design of the control system for internal workpiece transmission is a very complicated work content, and the design is relatively difficult. Therefore, it is necessary for relevant designers to pay more attention to the overall design of the control system of the internal workpiece transmission of the laser automatic fiber laser cutting machine based on the previous design experience, so as to be able to carry out the standardized laser The overall design of the control system of the automatic fiber laser cutting machine's internal workpiece transmission is to improve the overall operation and application effect of the laser's automatic fiber laser cutting machine.

This automatic fiber laser cutting machine control system applies the method of automatic marking and workpiece conveying cooperation. The overall design idea of u200bu200bthe control system is that when the control system detects the relevant workpiece, the PLC will gradually send the marking action execution command to the board after a delay of 1s. After the marking action is completed, the The board card sends a signal to its PLC that the marking operation is complete. After the PLC receives the signal that the marking operation is complete, it will issue a corresponding control command, allowing the entire operating table to gradually move to the right at high speed until the end of the linear module. After that, the motor will stop rotating. When the detected workpiece is removed, the motor will automatically make a reverse action, and the module will gradually return to the starting point. In this research, the control system designed two operation buttons, emergency stop and stop. If the operation button of stop is pressed, the control system will stop running, avoiding erroneous operation control situations under unsupervised conditions. The emergency stop button is mainly used when the control system is in an abnormal condition during actual operation. The operator can press the emergency stop button to cut off the power in time, so as to stop the operation of the system urgently. It can be restored to normal operation and control state after power-on.