Vibrating feeder also named vibratory feeder,
by:Lxshow
2020-05-07
Broken production line of vibrating feeder of the installation points three conditions:
Level installation. This type of installation is generally applied to materials uniform stable feeding. It can prevent their material. Slope down10 degrees. This type of installation is used in general raw material continuously feeding.
Slope downward 15 degrees. This type of installation is applicable to viscous or large water raw material continuously of feeding. Vibrates the feeding stimulus should be paid attention to during the situation:
Always check the amplitude of vibration motor, if discovery is unusual, shall be immediately stop. This is because of the vibration motor current and motor surface temperature requirements, not even before and after the amplitude about wave set.
When running two sets of vibration motor must reverse spin. If current appear unstable or a loudly noise, should stop soon. Vibrates the feeding machine maintenance: To a service-oriented brand integrity,As the professional manufacturer of complete sets of mining machinery ,like cement plant, Henan Hongxing is always doing the best in products and service.china mobile crushers:http://www.hx-crusher.com/mobile_crushing_station.html
Run before all bolts should be a vibration motor, especially the anchor bolt, continuous operation 3-5 hours should be retightened once.
Motor bearing is the broken production line of vibrating feeder mouth key equipment, so for its maintenance especially important also. The simple case every 2 months filling the lubricating oil, high temperature season every month should be filling the lubricating oil. And every half year motor to have to tear open repair a, internal bearing will change.
They are built for continuous operation. Each vibro feeder utilizes the forces set up by two synchronized, counter-rotating, heavy-duty, unbalanced Vibratory Motors, which are firmly fixed to the Feeder trough, in a specific angle to the feeding level. Feeders with unbalanced drives, vibrate freely on a support spring which is insulated against vibration transmission to base frame.
The both vibratory Feeder are used to control bulk products flow in bulk Handling plants, Like coke, Quartz, Mineral, Cement, Glass and many other industries Compared with other conveying means vibratory feeders have low energy consumption and cause little pollution. They are wear resistant and thus do not influence the quality and character of the product they handle.
Custom message
Related Products