So as discussed earlier sharpening can be done by using a
Purchase a mechanical sharpener and follow its manual guide to get your work done. Place the blade in the saw sharpening machine and take it towards yourself. Repeat the process until blade has achieved preferred sharpness, and then hone the blade with steel.
Hold a sharpening steel point down with its tip resting on a reducing board. Sharpening steel is a metal rod used to sharpen blades or saw blades. Using your other hand, hold the blade against the metal with the back of the blade in contact with the metal. Place most of the blade right in front of the metal. Rotate the blade with its cutting edge in contact with the base of the metal at approximately a 20-degree position. Take the whole length of the knife toward you, while moving it downwards along the base of the metal. Remember to maintain the appropriate angle. Do it again this step as many times as required to get the saw blade properly sharpened. Glide the other part of the blade against the steel as many times as needed.
Switch on grinding machine. It has a wheel that operates at a rapid speed, and is used for making sharpen edges of blades and tools. Place a water supply pipe near the grinder so as to minimize the heat produced by the process. Place the saw blade against the rotating grinder and move in gently around it. Tilt the blade to sharpen other end, and soak under water when required, and then hone it with steel.
Place a whetstone that has both rough and smooth sides on a flat and protected area. A whetstone is a sharpening rock used for blades and other resources. For dull blades, use the rough part first. Use the smooth part only for saw blades that are less dull. Put little bit of water or oil, then rub one edge of blade to the stone at an angle 20 - 30 degree. Repeat the process till the desired result is achieved.
If you are looking for the best saw sharpening machine manufacturers, go through Vollmer Technologies (vollmer-group.com). This is the genuine company to produce all mechanical machines.